Here share with you EASY steps to change Yamaha YZF R1 2001 mileage by Digiprog 3 V4.94. Easy to do even for DIY odometer correction!
Step 1.
Take apart the EEPROM chip Yamaha YZF-R1 93C46.
You can take a close look at as below:
In this case, you need the ST04 cable to connect 93C46 EEPROM chip with Digiprog iii.
Fit the chip with ST04 cable clip properly like this:
Connect ST04 cable with Digiprog iii and connect device to power supply.
Step 2
Device will power on. You will see an information message, click OK.
Input your device password to enter the main menu.
Go to “MOTORCYCLE” section
Scroll down to select “YAMAHA”, “YZF R1” then “C46 (2001)”.
It will show “93CS46 PLUG 1”, click OK to continue.
Step 3
You can see the old odometer value as 27584KM.
And just enter a new value like 40000KM, click OK and confirm it again.
Now you change Yamaha R1 mileage successfully using Digiprog iii Digiprog 3 odometer programmer!