Renault CAN CLIP interface ISO board

Outils de diagnostic de voitures

There was the following defect, resulting in periodic loss of CAN CLIP Renault communication over USB:
Due to the unprinted printed track on the ISO board, the resistor 102 was not connected to the 5v bus, with a suspense to the K-line on the 45th leg of the EPM7064 chip.
The defect is eliminated by setting the jumper.

renault-can-clip-iso-board

On this photo that would see that from the left pad there is no track (with nothing connected) – the resistor 102 is repaired

renault-can-clip-iso-board-resistor-102

And this shows the place where to solder the jumper.

renault-can-clip-iso

All good results in the finalization of the Clip!