Renault CAN CLIP V151 Installation, Connection (Personal Experience)

Last week, I purchased Renault CAN CLIP from China, and just got it yesterday. This are my package, which cost €97.00, much cheaper than others. It includes the Renault can clip interface
with a Renault 12pin cable, OBD II 16pin cable and USB Cable. Also, a CD for the software&video guide.
renault-can-clip-v151
The PCB board showed the same as the one displayed on the web, also.
renault-can-clip-pcb
Although with the help of video guide(https://www.youtube.com/watch?v=ZQj8mTWa_w8), I did not install the software smoothly. At first, I forgot exiting the antivirus software on Win 8. Too careless I am! But when I exited the antivirus to begin the installation, the error message “SPX CLIP Registration Client” appeared as follows:
CAN CLIP-SPX CLIP Registration Clien
Having searched it on forums, I was told that the software had better install on the computer with XP operation system, better American English Professional version system.
Finally, following our instruction and video, Renault CAN Clip driver was installed successfully.

Connection pic:
renault-can-clip-connect
Note:
Here I have some solutions for 5800 window when connected to the car.
5800 window, units of measurement appear 104Error 5800: Please check the power supply is connected, the normal connection indicator light red flashes.
If it is any problem of these two situations: reconnect, wait about 10 seconds before verification.
And follow the next two instructions to solve the problem:
1) The installed software can’t run in your computer system stably, there is no communication between the software and the device.
2). the computer USB interface does not work, try to use another one.

Chinese clone CAN CLIP I got worked well, also. Without any problem like what I saw on the forum before.

Also, the CAN CLIP worked well with my wife’s Renault Megane II 2003. Nice!

sales